Advertenties
Introduction to programming
The Programming menu allows you to make the following settings:
Camera name
-
Date and time
-
Picture adjustment for each camera
-
Motion sensor
-
Event memory
-
Dwell time
-
Key lock
-
All entered values are stored in non-volatile memory and are available even after a long power failure.
Important
To be able to perform the setting, you must be in the Programming menu of the ECOLINE Quad. This is
possible only from the Live mode.
To do this, briefly press the Menu key. The main menu is displayed. Use the arrow keys to navigate the
Programming menu. You can exit the Programming menu at any time by pressing the Menu key for at least
2 seconds.
Proceed as follows when programming:
1. Select the menu item to set.
2. Select the value to change.
3. Change the setting.
Select the menu item:
Enter the on-screen menu by briefly pressing the
Use the arrow keys ▲ (5) and ▼ (6) to move from one menu item to the next.
The cursor flashes at the selected position.
If there is no entry within ten seconds, the Quad returns automatically to Live mode.
Select the value to change:
Confirm your selection with the
Change the setting:
Change the value where the cursor is blinking. Use the +/- keys (7) and (8) to select a letter or
value. Possible values are:
0~9; A~Z; /:=-+. . To indicate a space, enter "_". When the first or last letter is reached, the
sequence begins again.
Menu key (1).
Menu key (1).
28
Advertenties
Hoofdstukken
