Inhoudsopgave
Advertenties
Vacuum Cleaner Clever Clean
AUTO
AUTO programme (15)
USE
Please Note!
■
Ensure that there are no larger, sharp
objects on the surface which is to be
cleaned.
■
Note the MAX marking on the dust
container. If during use the marking
is reached, empty the dust container.
Empty and clean the dust container
after each use. The fi lters must also
be regularly cleaned in order to pre-
vent overloading of the motor.
■
Switch the device off after each
surface has been cleaned as this will
considerably increase the operating
time on each battery charge. Char-
ge up the battery after use (see the
"Charging Up the Battery" chapter).
1. Select an accessory as required (see
the "Accessories" chapter) and attach
it to the device (see the "Assembly"
chapter).
2. Switch on the device by pressing the
On / Off switch (7) once. The device
will start vacuuming immediately. The
touch display (6) lights up.
3. If necessary, the suction strength can
be changed manually via the touch
display by touching the fi eld
. If the AUTO symbol is touched,
the intelligent suction strength con-
trol can also be set (see the "Touch
Display" chapter).
4. Move the device over the surface to
be cleaned.
5. If the device is to be switched off
again, press the On / Off switch again.
automatic suction strength setting
depending on level of dirt etc., is shown
via the ring (18): green = lowest level;
it gradually turns red when the suction
strength is increased; completely red =
highest level
CLEANING AND STORAGE
Please Note!
■
Do not immerse the HEPA fi lter in
water or rinse under running water in
order to prevent damage. It is neither
machine-washable, dishwasher-safe
nor suitable for tumble drying.
■
The dust fi lter is neither machine-
washable, dishwasher-safe nor suita-
ble for tumble drying! Only ever dry
it in the air, and never use a hair dryer
to do so.
■
Do not use any sharp or abrasive
cleaning agents to clean the housing.
They may damage the surfaces.
The HEPA fi lter may lose some of
its colour over time. This is normal
and does not have any adverse
effect on function.
Emptying the Dust Container
1. Detach the dust container (3) from
the motor unit (E) (see the "Assem-
bly" chapter – "Detaching / Inserting
the Dust Container").
2. Hold the dust container over an open
dustbin. The distance from the dust-
bin should be as small as possible so
or
that the dust does not spread in the
surrounding air.
3. Press the tab (2) on the dust contai-
ner. The lid of the dust container (1)
will open and the dirt will fall out.
4. To close it, press the lid onto the
dust container. The tab must engage
audibly.
EN
19
Advertenties
Hoofdstukken
Inhoudsopgave
