Download Inhoudsopgave Inhoud Print deze pagina

Before Initial Use; Charging Up The Battery - MAXXMEE Clever Clean Handleiding

Inhoudsopgave

Advertenties

EN
WARNING – Danger from
Rechargeable Batteries!
The battery must not be taken apart,
thrown into a fi re, exposed to high
temperatures of over +40°C, im-
mersed in liquids or short-circuited.
The battery could ignite or explode.
Ensure that the motor unit and the
battery cannot get wet. Do not use
the device if liquid has got inside it.
The battery could ignite or explode.
Do not cover the device and the
mains adapter during charging in
order to prevent it from catching fi re.
Do not insert anything into the ven-
tilation openings of the device and
make sure that these do not become
clogged.
Remove a dead battery from the de-
vice immediately. Clean the contacts
before a new battery is inserted.
NOTICE – Risk of Damage to
Material and Property
Make sure that the mains cable is not
squashed, bent or laid over sharp
edges and does not come into con-
tact with hot surfaces.
Do not wind the mains cable around
the device or the mains adapter.
The device should only be used if it
has been fully and correctly assem-
bled! The dust container and the
fi lters must be inserted and must
not be damaged! If the dirt were to
get inside the motor unit, this could
damage the motor.
Remove the mains adapter from the
plug socket if a fault occurs during
charging or if a thunderstorm is
expected.
The device must be switched off
when the mains adapter is pulled
out or inserted into the plug socket.
Always pull the mains adapter and
never the mains cable to disconnect
the device from the mains power!
16
Do not use the device when it is still
connected to the mains adapter.
Never pull or carry the device by the
mains cable.
Protect the device from heat, naked
fl ames, extreme temperatures, per-
sistent moisture, wet conditions and
impacts.
Use only original accessories from the
manufacturer in order to guarantee
that there is no interference that may
prevent the device from working and
to avoid possible damage. The LEDs
cannot be replaced.

BEFORE INITIAL USE

Charge up the battery (F) (see the
"Charging Up the Battery" chapter).
Attach the wall bracket (B) (see the
"Attaching the Wall Bracket" chapter).
CHARGING UP THE
BATTERY
Please Note!
Charge up the battery fully before
you fi rst use the device in order
to achieve the maximum charging
capacity. If the battery is discharged
during use, it should be fully charged
up again before it is next used.
Only connect the mains adapter to a
plug socket that is properly installed
and matches the technical data of the
device. The plug socket must also be
readily accessible after connection so
that the connection to the mains can
quickly be isolated.
Before inserting the battery, check
whether the contacts are clean and
clean them if necessary.

Advertenties

Inhoudsopgave
loading

Inhoudsopgave