Inhoudsopgave
Advertenties
Chain catcher
The chain catcher (30) prevents a broken or jumped off saw
chain from hitting the operator during sawing.
Check the chain catcher on a regular basis and replace
it if it is damag
ed.
Silencer / exhaust outlet
Check the tight seat of the screws on the silencer (25) on a
regular basis
If they are loose, tighten them hand-tight with the engine
in cold condition.
Do not retighten the silencer screws when the engine is
ho
t.
Clean the exhaust outlet on a regular basis
Adjusting the carburetor (idle speed)
The carburetor is factory-set to the correct idle speed so that
the correct fuel-air mixture is fed to the engine.
An incorrect carburetor adjustment results
engine damages. Do not continue working with the
chain saw in such a condition.
In the cases below the carburetor (idle spe
corrected:
- Speed too high (saw chain continues to move
- Err
atic running or lack of acceleration (idle speed too low)
- A
d
justment to weather conditions and temperatures
C
ontact a specialist workshop an
adjustment done.
Cleaning
Clean the chain saw thouroughly after each application so that
the faultless function is kept.
Clean the case w
ith a soft brush or a dry cloth.
Water, solvents and polishing agents shall not be
applied.
Make sure that the vent slots (32) of the cover (26)
and the engine's cooling fins (33) for engine cooling are free
and clean (risk of overhea
If heavily contaminated, clean the chain s
commercial chain cleaner.
Clean the oil flow canal (19) with a clean cloth or a
bru
sh.
Clean the brake strap (20) at the cover (13) using a
brush.
27
All manuals and user guides at all-guides.com
in severe
ed) has to be
in idle speed)
d have the carburetor
ting).
aw using a
T
T
r
r
a
a
n
n
Before each transport:
− switch off device
− wait for stop of chain saw
− attach the scabbard on the guide bar
Carry the product with the front handle. The guide bar
sha l show to the rear side.
l
When transporting the product within a car put it in the boot
or n a separate loading area. Secur
o
tip i
p ng over, damages and fuel spillage.
S
t
o
r
S
t
o
r
Store unused equipment in a dry, locked place out of the
reach of children.
To extend the service life of the saw and
operation, before storing for a longer period:
Operate the engine
until the car
thoroughly clean th
e device.
Empty the fuel tank completely.
Empty the oil tank completely.
Dispose of remainders of fuel/saw chain oil according
to relevant regulations (environmentally compatible).
Tipp:
Some chain oils tend to e
period. For this reason the oil sy
before a longer storing with
cleaner. Fill the cleaner up to the middle (appr. 50 ml)
into the empty oil tank. Close the tank. Operate the chain
saw w
ithout installed guide bar and chain until all of
cleaner came out of the oil outlet of the chain saw.
Aft
er cleaning, immerse the saw chain in an oil bath for a
sho
rt time and wrap it then with oiled paper.
s
s
p
p
o
o
r
r
t
t
e the chain saw against
a
g
e
a
g
e
guarantee smooth
buretor is empty.
ncrustations after a
longer
stem should be flushed
a
commercial chain saw
the
Advertenties
Hoofdstukken
Inhoudsopgave
