Inhoudsopgave
Advertenties
EN User Guide
hex key. The housing can then be moved. Be
sure to re-tighten the screw once you have
set the desired position.
7
Maintenance
7.1
Servicing instructions
• Dry the filter and the air inlet of the tool.
• Lubricate the quick coupling to prevent
blockages.
• Lubricate the device daily with a good grade
of pneumatic tool oil.
• If you do not use a lubricator for the air line,
allow one teaspoon of oil to run through the
device.
• The oil can be injected into the air inlet of the
tool or into the hose at the nearest
connection to the air supply, then let the tool
run.
• Anti-corrosive oil is suitable for pneumatic
tools.
• Pneumatic
tools
throughout the entire life of the tool. The air
motor and the bearing use compressed air to
start the tool. The moisture in the compressed
7.2
Changing the needles
The needles of the needle scaler are subject to
natural wear. They can easily be replaced with
19 new 3-mm thick needles.
1.
To do this, remove both screws using the
supplied hex key.
2. Then pull off the front housing.
3. Now unscrew the barrel from the handle.
8
Disposal
An old device can be returned to a disposal
point where it will be disposed of in
accordance with the national law on recycling
and waste. The device and its accessories are
composed
of
various
9
Comment
The operating instructions are subject to
change
without
notice.
assumes no responsibility for the loss of
products. The information in these operating
STIER Industrial GmbH
must
be
lubricated
materials.
Faulty
Our
company
air causes the compressed-air motor to rust;
you must lubricate the motor daily.
• Avoid storing the device in a location with
high humidity. If the tool is left as it is used,
the residual moisture inside the tool can
cause rust.
• Lubricate the tool before storage and let it run
for a few seconds.
• Regular inspection of spindles, threads and
clamping devices for wear and tolerances in
the event of any tool clamping.
• If the tool is too damaged to continue to be
used, recycle the raw materials instead of
disposing of it as waste. The machine,
accessories and packaging should be sorted
for environmentally friendly recycling. Check
with your local authority or dealer for
recycling
4. In the barrel you will find a sleeve with 19
holes. Pull out the worn needles and insert
the new needles.
5. The device can then be reassembled in the
reverse order.
components must be treated as hazardous
waste and disposed of in accordance with
legal regulations. The packaging is made of
raw materials and can therefore be reused, or
taken to a collection point.
instructions cannot be used as justification
for
using
the
product
application.
24
advice.
for
any
other
EN
Advertenties
Hoofdstukken
Inhoudsopgave
