Inhoudsopgave
Advertenties
EN User Guide
NOTE
The actual torque of a fastener is directly
related to the connection strength, the tool
speed, the condition of the socket and the
6.4
Set-up of air supply and connection hazards
#
Designation
1
End piece adapter
2
Whip hose
3
Adapter
4
Lubricate daily
5
Coupling
6
End piece adapter
7
Main hose
Recommended air line component
• For optimal operation, you should install a
regulator, a lubricator and an inline filter.
• If you are not using an automatic
lubrication system, pour a few drops of
pneumatic tool oil into the air line
connection before starting the device. Add
6.5
Application
NOTICE
Connect the needle scaler to a suitable
compressor. Make sure that the air pressure
does not exceed 6.2 bar. Failure to do so may
result in damage or increased wear and tear to
the device.
STIER Industrial GmbH
time the tool is allowed to act. Use the
simplest possible tool and socket connection.
Each connection absorbs energy and reduces
power.
#
Designation
8
Coupling
9
Lubricator
10
Regulator
11
Filter
12
Shut-off valve
13
Pipes and shaped parts
14
Release daily
15
Air supply
more after every hour of continuous
operation.
• Do not exceed the maximum air pressure of
6.2 bar (90 psi) or the value indicated on
the
rating
• Always wear appropriate protective clothing
and safety glasses when derusting
• Operate the trigger of the device and guide
the needles over the surface of the workpiece
until it is sufficiently derusted.
• By pulling the housing in and out, the spread
of the needles can be adjusted to the range
required. To do this, the front screw on the
device must be loosened using the supplied
23
plate
of
the
device.
EN
Advertenties
Hoofdstukken
Inhoudsopgave
