Inhoudsopgave
Advertenties
Problems
The machine does not froth milk.
There is too much froth in the hot
milk
Please contact Saeco customer service for problems not covered in the above trouble shooting section or when
a problem cannot be resolved.
SAFETY RULES
Never place live parts in contact with water: danger of short circuit! Steam and hot water can cause scalding!
I
NTENDED USE
The Milk Island is exclusively intended for household use only.
The Milk Island cannot be used alone but must be connected to a preset coffee machine.
Do not make any technical changes or use the machine for unlawful purposes since this would create serious hazards!
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
P
OWER SUPPLY
The Milk Island is powered by low voltage from the coffee machine to which it is connected by a special electro-
hydraulic connector.
P
(
OWER CONNECTOR
ELECTRO
Never use the Milk Island if the electro-hydraulic power connector is faulty.
If damaged, the electro-hydraulic connector must be replaced by the manufacturer or its customer service department.
The connector must not come into contact with liquids, wet parts or other substances that could alter the effectiveness
of the electrical contacts or cause a short circuit.
TROUBLE SHOOTING - SAFETY RULES
Causes
Milk with unsuitable fat content.
The valve located in the cover is dirty.
The led on the base of the Milk Island
is red.
Cover components not installed
correctly.
Froth selection lever in the wrong
position.
The coffee machine is not ready to
dispense steam.
Froth selection lever in the wrong
position.
-
)
HYDRAULIC
Solutions
Change the type of milk used.
Press the fast cleaning button 2-3 times
Wash the valve.
Firmly push down the carafe..
Check cover assembly.
Place the lever on the "
Check the machine operation.
Place the lever on the "
19
" symbol.
" symbol.
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
