Inhoudsopgave
Advertenties
Operating Instructions
L4000 system
8010009/1KO6/2023-08-16
Subject to change without notice
Technical data
6)
Inputs
6)
Outputs
Switching outputs OSSDs
6 )
Switching voltage
(active, U
)
eff
6)
Switching voltage
(inactive)
Switching current
Leakage current
7 )
Load capacity
Switching sequence
Load inductance
8 )
Applies to the voltage range between -30 V and +30V.
5)
As per IEC 61131-2.
6)
In case of fault (0 V cable open circuit) the max. leakage current flows in the OSSD cable.
7)
The downstream controller must detect this status as LOW. A safe PLC (Programmable Logic Controller) must
be able to identify this status.
The maximum rated load inductance is higher with lower switching sequence.
8)
SICK AG • Industrial Safety • Germany • All rights reserved
minimum
Reset buttonExternal device
monitoringDeactivate reset
buttonDeactivate external device
monitoring4 receiver inputs
4 sender outputs
2 PNP semiconductor, short-circuit
protected
5 )
, cross-circuit monitored
HIGH
17.5 V
24 V
LOW
Depending on load inductance
Chapter 9
typical
maximum
28.8 V
1.3 V
0.5 A
0.3 mA
2.2 µF
1.9 H
en
101
Advertenties
Hoofdstukken
Inhoudsopgave
