Inhoudsopgave
Advertenties
Electrical connection
The appliance is intended for connection to alternating
current. The connection values for voltage (V) and
frequency (Hz) are given on the nameplate
the cabinet.
Power must be connected via a wall socket with switch.
The wall socket should be easily accessible.
All earthing requirements stipulated by the local
electricity authority must be observed. The appli-
ance plug and wall socket should then give cor-
rect earthing. If in doubt, contact your local suppli-
er or an authorised electrician.
WARNING
The flexible cord (mains lead) fitted to this appliance
has three cores for use with a 3-pin 13-amp or 3-pin
15-amp plug. If a BS 1363 (13-amp) fused plug is
used, it should be fitted with a 13-amp fuse.
IMPORTANT
The cores in this mains lead are coloured in accord-
ance with the following code:
GREEN-AND-YELLOW: EARTH
BLUE: NEUTRAL
BROWN: LIVE
These colours might not correspond with the colour
markings identifying the terminals in your plug.
Proceed as follows:
Connect the GREEN-AND-YELLOW core to the
plug terminal marked "E" or by an earth symbol,
or coloured GREEN or GREEN-AND-YELLOW.
Connect the BLUE core to the plug terminal
marked "N" or coloured BLACK. Connect the
BROWN core to the plug terminal marked "L" or
coloured RED.
All manuals and user guides at all-guides.com
3
in
Illustration
door from right-hinged to left-hinged - or vice versa.
Lay the appliance on its back with the door up.
Remove the door handle.
Take off the upper hinge bracket and remove the door.
Unscrew the adjusting screws from the lower hinge
brackets and take the brackets off.
Move the pin on the hinge bracket to the other
threaded hole before refitting the hinge brackets
on the opposite lower side of the cabinet.
Remember to replace the shim washer on the
hinge pin.
Refit the adjusting screws.
Replace the door.
Refit the upper hinge bracket on the opposite side.
Refit the door handle.
Specifically for Fresh line models
Switch the cabinet off by turning the thermostat
knob to "0". Empty the cabinet and begin by
removing the door handle. Tilt the cabinet 40° in
order to gain access to the lowest hinge. Remove
the adjustable feet. Remove the three screws
holding the lowest bracket in place using a Phillips
screwdriver. (1). Remove the door and unscrew
the three screws from the bracket on the base on
the cabinet (2).
Before refitting the brackets on the opposite side of
the cabinet, move the threaded pin on the hinge
bracket to the other threaded hole. Remove the
threaded pin under the control panel using a Phillips
screwdriver and move it to the opposite side. (3).
Refit the door and screw the bottom hinge into
position using a Phillips screwdriver. Refit the
adjustable feet and, finally, refit the door handle.
23
You can change the
door from right-hinged
to left-hinged or vice
versa yourself
4
shows how easy it is to change the
GB
4A
Advertenties
Inhoudsopgave
