Inhoudsopgave
Advertenties
EN
7
Troubleshooting
7.1
General
Consult the Holmatro dealer if the listed solutions do not give the desired result, or in case of other
problems. For malfunctions or repair, always specify the model and serial number of the equipment.
7.2
The control slide shifts no longer
/i
Possible cause
The control slide is damaged.
7.3
The plunger has seized
/i
Possible cause
The plunger extends beyond the red mark.
The plunger has seized due to corrosion.
The screw or the gear has seized.
8
Maintenance
8.1
General
Meticulous maintenance of the equipment preserves the operational safety and extends the life of the
equipment.
WARNING
When performing maintenance activities, always comply with the relevant safety regulations.
Wear the prescribed personal protection equipment.
8.1.1
Dangerous substances
WARNING
Used or leaked fluids, and any other products consumed during the activities, must be
collected and disposed of in an environmentally responsible way.
8.2
Maintenance materials
/i
Application
Steel parts
Contact the Holmatro dealer for information on spare parts.
26
All manuals and user guides at all-guides.com
Type of maintenance material
WD-40 preservative oil
Tectyl ML from Valvoline (long term preservation)
917.219.005_005
Solution
Make the slide run again by sanding or grinding
away the upset edges or damage.
Solution
Remove the ratchet housing. Place an adjustable
wrench on the ratchet shaft. If possible, load the
plunger and turn the ratchet shaft anti-clockwise.
Clean the screw and gear and remove the
corrosion. Refer to section 8.4.3.
Make the plunger run by removing the corrosion.
Amount
As required
As required
JJ/PL
Advertenties
Inhoudsopgave
