Inhoudsopgave
Advertenties
2. Slowly lift the drawer.
3. Pull the drawer out fully.
To install the drawer, do the above steps in
the opposite sequence.
13.6 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
14. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
14.1 What to do if...
Problem
There is no spark when you try to
activate the spark generator.
The flame extinguishes immediately
after ignition.
The flame ring is uneven.
1. Turn off the oven. Wait until the oven is
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The back lamp
1. Turn the lamp glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
4. Install the glass cover.
Possible cause
The hob is not connected to an elec‐
trical supply or it is connected incor‐
rectly.
The fuse is blown.
Burner cap and crown are placed in‐
correctly.
Thermocouple is not heated up suf‐
ficiently.
Burner crown is blocked with food
residues.
cold.
heat-resistant lamp.
Remedy
Check if the hob is correctly connec‐
ted to the electrical supply. Refer to
the connection diagram.
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
Place the burner cap and crown cor‐
rectly.
After lightning the flame, keep the
spark generator activated for equal
or less than 10 seconds.
Make sure that the injector is not
blocked and the burner crown is
clean.
ENGLISH
51
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
