6. HOB - DAILY USE
WARNING!
Refer to Safety chapters.
6.1 Ignition of the hob burner
Always light the burner before you put on
the cookware.
WARNING!
Be very careful when you use open fire in
the kitchen environment. The
manufacturer declines any responsibility
in case of the flame misuse.
1. Turn the knob for the hob
counterclockwise to the maximum gas
flow position
the burner.
2. Keep the knob for the hob pushed for
equal or less than 10 seconds to let the
thermocouple warm up. If not, the gas
supply is interrupted.
3. Adjust the flame after it is regular.
WARNING!
Do not keep the knob pushed for more
than 15 seconds. If the burner does not
light after 15 seconds, release the knob,
turn it into the off position and try to light
the burner again after minimum 1 minute.
and push it down to light
If after some tries the burner does not
light, check if the crown and its cap are in
the correct position.
In the absence of electricity you can
ignite the burner without an electrical
device. In this case approach the burner
with a flame, push the relevant knob
down and turn it to maximum position.
Keep the knob pushed for equal or less
than 10 seconds to let the thermocouple
warm up.
If the burner accidentally goes out, turn
the knob to the off position and try to light
the burner again after minimum 1 minute.
The spark generator can start
automatically when you switch on the
mains, after installation or a power cut. It
is normal.
ENGLISH
43