2. Operation
A
D
˚C
TEMP.
1
TIMER SET
3
3. Care and cleaning
A
D
B
C
ON OFF
˚C
CLOCK
ON/OFF
FILTER
CHECK TEST
2
B
C
2) Set the mode to continuous as follows
button to display D
1 Press
3) Set the time to start the unit as follows
button to display B
2 Press
3 Press
button to set the time that you want the unit to start.
TIMER SET
The start time is displayed at A.
4) Set the time to stop the unit as follows
button to display C
2 Press
3 Press
button to set the time that you want the unit to stop.
TIMER SET
The stop time is displayed at A.
5) Set the mode to timer as follows
button to display D
1 Press
3.1. Cleaning the filters and the indoor unit
Cleaning the filters
• Clean the filters using a vacuum cleaner. If you do not have a vacuum
cleaner, tap the filters against a solid object to knock off dirt and dust.
• If the filters are especially dirty, wash them in lukewarm water. Take care
to rinse off any detergent thoroughly and allow the filters to dry com-
pletely before putting them back into the unit.
Caution:
• Do not dry the filters in direct sunlight or by using a heat source,
such as an electric heater: this may warp them.
• Do not wash the filters in hot water (above 50 °C), as this may warp
them.
• Make sure that the air filters are always installed. Operating the
unit without air filters can cause malfunction.
Caution:
• Before you start cleaning, stop operation and turn OFF the power
supply.
• Indoor units are equipped with filters to remove the dust of sucked-
in air. Clean the filters using the methods shown in the following
sketches.
Filter removal
Caution:
• In removing the filter, precautions must be taken to protect your
eyes from dust. Also, if you have to climb up on a stool to do the
job, be careful not to fall.
• When the filter is removed, do not touch the metallic parts inside
the indoor unit, otherwise injury may result.
I PLFY-P·VAM Series
1 Pull the knob on the intake grille in the direction indicated by the
arrow and it should open.
2 Open the intake grille.
3 Release the knob on the center edge of the intake grille and pull the
filter forward to remove the filter.
A Knob
B Grille
C Intake grille
D Filter
.
ON
.
OFF
.
.
5