Inhoudsopgave
Advertenties
is a very long-life and energy-saving light source.
The light duration depends on the amount of sunlight,
the angle of light on the solar cell and the tempera-
ture (the rechargeable battery capacity is tempera-
ture-dependent). A vertical angle of light at temperatures
above the freezing point is ideal. The rechargeable
battery
does not achieve maximum capacity until
10
after several charge and discharge cycles.
Preparing for use
Note: Remove all packaging materials from the
product.
Installing the product
Install the product in accordance with Figures A, C:
1. Move the ON / OFF switch
position to switch the light on.
2. Insert the decorative bird
3. Place the housing
4
4. Take out the ground stake
the pole
with the tip facing downwards.
5
5. Your product is ready for use.
Setting up the product
Insert the assembled product far enough into
the ground (lawn, flower bed) for it to be stable.
Make sure you keep proper footing and balance
at all times. Do not use any force when assembling
or setting-up the product, e.g. hammer blows.
This will damage the product. In order to achieve
the best result, set the product up in a place
where the solar cell will get direct sunlight for
as long as possible.
Make sure that the solar cell is not influenced by
any other source of light such as yard or street
lighting as otherwise the light will not come on
in twilight.
The light automatically switches on in twilight
conditions and off again when normal outdoor
lighting conditions return.
8
GB/IE/NI
into the ON
8
into the housing
1
4
on to the pole
.
5
and insert it into
6
Replacing the rechargeable
battery
The rechargeable battery should be replaced every
12 months to ensure optimum performance.
1. Switch off the light with the ON / OFF switch
2. Loosen the fastening screws
cross head screwdriver and then lever out the
battery compartment cover
a slot screwdriver (see Fig. B).
3. Take care not to damage the cables and cable
connections (see Fig. B).
4. Exchange the old rechargeable battery
a new one. Take care about the correct polarity,
when inserting the new rechargeable battery.
The polarity is indicated in the battery compart-
ment. The new rechargeable battery has to have
the same technical data like the old one.
5. Now again fasten the battery compartment
cover
, fasten the fastening screws
9
using a small cross head screwdriver. Slide the
.
ON / OFF switch
Charging the rechargeable
battery
Note that the product must be switched on when the
rechargeable battery is charging.
The charging time of the rechargeable battery when
the solar cell is used depends on the intensity of the
sunlight and the angle of incidence of the light on
the solar cell. Place the solar cell as perpendicular
as possible to the angle of incidence of the light. In
this way you will receive the highest light levels.
Maintenance and care
The LED cannot be replaced. The product is mainte-
nance-free, except for any necessary change of
rechargeable battery.
Clean the product regularly with a dry, lint-free
cloth. Use a slightly dampened cloth to remove
more stubborn dirt.
by using a small
7
with the help of
9
10
by
7
to the position ON.
8
.
8
to
Advertenties
Hoofdstukken
Inhoudsopgave
