Inhoudsopgave
Advertenties
6. Initial operation
Measure sig-
nal strength
38 / 148
Other transmitters in the 868 MHz range (e.g.
wireless microphones or garage door openers)
If you are not satisfied with the operational safety, you
can change the installation location or use an external
antenna (see manual).
You can measure the signal strength of the device with
a measuring device (BAMO tester). If you would like to
use a BAMO tester, you can obtain it from SimonsVoss
Technologies GmbH with the article number
WN.TESTER.BAMO.EU/WN.TESTER.BAMO.US or
SI.GN.TESTER.BAMO.EU. The exact procedure is
described in the manual of the BAMO tester.
NOTE
Measurement errors due to structural changes
Structural changes and other wireless devices influ-
ence the WaveNet wireless network. If the WaveNet
radio network is measured before other components
are installed, the measurement results may sub-
sequently be falsified.
1. Do not carry out measurements in the unfinished
building, but in the finished condition (including po-
tential sources of interference).
2. If in doubt, plan for reserves.
If you want to operate the devices safely, you should at
least measure the following signal strengths:
First measurement: 70% to 100%.
Second measurement: 80% to 100%.
SmartBridge Gateway Node 2
RouterNode 2
EN
Advertenties
Hoofdstukken
Inhoudsopgave
