Inhoudsopgave
Advertenties
EN commeo initial operation/Setting by radio
5. commeo initial operation/Setting by radio
commeo initial operation
The commeo initial operation is only possible using commeo transmitters. To com plete
the settings in the receiver, the receiver must be selected with a trans mitter in SELECT
mode. In SELECT mode, there is only one connection at a time to a re ceiver. Only this
one can be moved and set.
5.1. Selection of a receiver
By pressing the SELECT button for 3 seconds the transmitter will be put into the
SELECT mode. After the SELECT mode has been started, the status LED will start to
flash quickly and the transmitter will look for the receiver. The status LED being lit in
green indicates that the receiver has been found and the status LED will flash slowly in
orange. The first receiver completes a brief confirmation run. If no receivers have been
found this will be indicated by the status LED being lit in red.
Receiver selection with non-programmed transmitter/initial operation
➧
>1 s
3 s
or
Receiver selection with programmed transmitter
1. Select the transmitter channel on which the receiver is programmed.
2. Push the SELECT button at the transmitter for 3 seconds. The transmitter
is in SELECT mode.
3 s
Note: The receivers found by this method can now be found using another non
programmed transmitter within 4 minutes. Press the SELECT button on the additional
transmitter for 3 seconds for this purpose. The transmitter is in SELECT mode. All
settings can now be completed with both transmitters.
1. Interrupt the voltage supply of the receivers for
> 1 second. The receivers can be found within the next
4 minutes.
2. Push the SELECT button at the transmitter for 3 seconds.
The transmitter is in SELECT mode.
50
Advertenties
Hoofdstukken
Inhoudsopgave
