Inhoudsopgave
Advertenties
Setting of the end positions
4. Setting of the end positions
4.1. Delivery status
In the SELVE delivery status no end positions or transmitters are programmed into
the radio motor! In this state, the motor can be operated in deadman's operation only.
Safety functions are deactivated at delivery and will only become active after both end
positions are set.
In delivery status the SEM PlusRC is in semiautomatic programming mode. This will
be signalized by a short up and down movement when connected to mains.
4.2. Setup functions
The end positions setting of a SELVE radio motor is possible via:
• the setting switch for radio motors (item no. 290109) or with
• any standard switch (only in semi-automatic mode) or with
• any standard commeo or iveo transmitter.
4.3. Mechanic requirements
When using the SEM PlusRC the awning fabric will often be connected directly with
the fabric shaft.
Caution:
There is no automatic setting of the lower end limit when using the SEM PlusRC. The
lower end limit has always to be runup to or also set.
Caution:
When setting in semiautomatic setting mode, a fixed upper end limit has to exist.
4.4. Selection table for settings
Setup-mode/end positions in
operation
Semiautomatic setupmode
bottom position, top stop with
release*
Manual setupmode
bottom position, top stop with
release*
Manual setupmode
bottom position, top stop without
release
* Both setting procedures are leading to the same result: bottom position: point, top position: limit
stop/relief
Setting switch
commeo radio
4.5.1. (page 47)
5.2.1. (page 53)
4.5.2. (page 48)
5.2.2. (page 54)
4.5.3. (page 49)
5.2.3. (page 55)
45
EN
iveo radio
6.1.1. (page 60)
EN
6.1.2. (page 61)
6.1.3. (page 62)
Advertenties
Hoofdstukken
Inhoudsopgave
