Inhoudsopgave
Advertenties
The motor is running but it
does not spray
The motor works but the
spray does not reach the
pressure or spraying is
irregular.
The motor does not stop
when the handle is released.
The handle does not close
The motor runs intermittently
when spraying
WARRANTY
8
• Our products are guaranteed for a period fixed according to the current legislation in each country, from the date of
purchase by the user, against any manufacturing or material defect.
• The warranty is strictly limited to the free replacement of parts recognised as defective by our services. The warranty
shall not apply in the event of misuse of our materials, disassembly and/or modifications of our devices, and for
parts subject to normal wear and tear that require maintenance. The warranty will not apply in cases of negligence,
recklessness and non-rational use of the material.
• The shipping and transport costs of the parts under warranty, as well as any labour not carried out in our manufacture,
will be borne by the user.
• To make the guarantee effective, please refer to us, free of shipping costs, the part relating to the claim along with the
invoice or purchase voucher.
EC AND UKCA DECLARATION OF CONFORMITY
9
The company GOIZPER S. Coop. C/Antigua 4, 20577 ANTZUOLA (GUIPUZCOA) SPAIN declares, under its sole responsibility,
that the IK e 15 BS machine (8.30.75 / 8.30.75.1 / 8.30.75.2) has been manufactured following the guidelines defined
by the ISO 9001 Management System and strictly complies with the harmonised standards: UNE-EN ISO 12100:2012 / EN
ISO 14982:2009
Name: AITZIBER URIARTE
Position: TECHNICAL DIRECTOR
Clean the hydraulic circuit
The amount of fluid in the sprayer
Cleaning the suction filter of the tank (Ref. 1251)
Hydraulic connections and leakages
Air in the hydraulic circuit
The condition of the nozzle
Check if the pump or the electronics are damaged
The amount of fluid in the sprayer
Cleaning the suction filter of the tank (Ref. 1251)
Air in the hydraulic circuit
Hydraulic connections and leakages
Check if the pump is damaged
The condition of the joints
Cleaning the nozzle, its filter and handle filter. [3.3]
Antzuola, 19 November 2020
Raise the appliance to table height and place
the handle in a lower height, with the appliance
switched on and the handle activated. Hold this
position for a few seconds. Always perform the
operation with water
Fill the sprayer with the product to be
sprayed
Clean the filter if necessary
Tighten any joint if necessary
Stop the engine and restart the equipment to
spray for a few seconds with the lance pointing
upwards and taking the necessary safety
precautions
Replace the nozzle if damage is perceived or
considerable wear and tear is discerned.
Contact the distributor
Fill the sprayer with the product to be
sprayed
Clean the filter if necessary
Stop the engine and restart the equipment to
spray for a few seconds with the lance pointing
upwards and taking the necessary safety
precautions
Tighten any joint if necessary
Contact the distributor
Change and grease the joints or the filter
with joints.
Clean the filters if necessary
Advertenties
Inhoudsopgave
