Advertenties
You can set a delayed start time using the timer button
and press the timer button, this will be visible on the unit. Each time you press the
timer button, one hour is added to the start time. The display shows the number of
hours set and counts down at the end of each hour. The timer lamp also switches on.
The unit starts automatically at the end of the set time. The standard temperature is
23°C (note it is not possible to set the thermostat using the buttons).
If the weekly programme is not set and if no temperature has been set using the
remote control, the unit will switch off automatically after 12 hours.
Operation using the remote control:
Please note: the remote control only works if the emitter on the remote
control can make contact with the receiver on the unit.
Make sure that the unit is in standby mode (S) (use the main switch).
Press the power button
show Fig. A.
Press the function button
The display will show Fig. B.
Press the button again and the heating will switch to full power. The
display will show Fig. C.
Press the function button a third time and the unit will return to mode A.
The timer button
the timer button on the unit.
Set the day and time:
Make sure that the unit is in standby mode (S) (use the main switch).
You can also set the day and time while the unit is switched on.
Press the SET button
plus and minus buttons
Press SET again to see the minutes. The display shows "30" and you
can use the plus and minus buttons to set the number of minutes,
from 00 to 59.
Press SET again and the display will show
minus buttons to set the day: Monday = d1, Tuesday = d2, etc.
Finally, press
mode it was in before you set the day and time. Press SET to check
the day and time.
Set the temperature:
Make sure the unit is switched on then press the plus or minus
button; the standard setting is "23". Press the plus or minus button
until you have reached the required temperature (between 10 °C
and 49 °C). Press OK to confirm the setting. The display shows
the set temperature and the power, for example:
If you have set the temperature, the unit selects the power
required: full power if it needs to heat the room by more than 2 °C
and low power if it needs to heat the room by less than 2 °C. Once
the unit has reached the set temperature, the heating element is
switched off but the ventilator remains switched on for another 3
minutes. This circulates the air in the room so that the unit can
sense whether the room is cooling down. The unit returns to
to switch the ventilator on; the display will
to switch the heating on, on low power.
on the remote control works in the same way as
once; the display now shows "12". Use the
/
to set the hour (from 0 to 23).
to confirm the settings. The display will return to the
. Set the unit to standby (S)
; use the plus and
29
Advertenties
