Advertenties
Location and Connection
Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact your
vendor for inspection or replacement.
Select a suitable place for the device, taking into account the safety instructions. The
unit must be installed so that the buttons cannot be touched by anyone in the bath or
shower. The SANI-FANHEAT 2000R has to be hung from a wall and therefore may
not be used in a lying, leaning, hanging or standing position! The wall on which the
device is hung has to be firm, flat and perfectly vertical and made from non-
inflammable material that cannot melt. It has to be at least 20 cm away from side walls
and the bottom has to be at least 180 cm.
The heater has to preferably (and definitely in damp
rooms) be positioned at and permanently connected
to an electric socket. This connection may only be
made by a qualified electrician and, for that reason,
is not described here.
In this booklet, for reasons of safety, use with a plug
should be assumed; when there is a permanent
connection, any passages about the plug do not
apply.
Drill 2 holes (8 mm.) in the wall at the selected spot:
horizontal to one another with a distance of 18,7 cm. Insert plugs into the holes and
insert screws into the plugs (included). Leave the screws protruding by 5 mm. Hook
the heater using the suspension eyes over the screws, slide it as far as possible to the
left and pull the heater downwards.
Attach the heater using the materials supplied (see diagram). Place the bracket on top
of the heater with the short side against the wall. Mark the location of the hole on the
wall and remove the heater. Drill a hole at the marked spot and insert a plug. Now
hang the heater in place and screw the bracket to the wall, as
shown in the diagram. The heater is now installed.
Using for the first time and Operation
Make sure that the main switch is OFF (O)
Unroll the electrical cable entirely and insert the plug into a
suitable 220/240V socket.
Set the main switch to ON (l). The display will show "S" (standby).
Manual operation using the buttons:
Press the F button once. The ventilator will switch
on and the display will show Fig. A.
Press the button again and the heating will switch
on, on low power. The display will show Fig. B.
Press the button a third time and the heating will
switch to full power. The display will show Fig. C.
Press the button a fourthtime and the unit returns
to standby (S). The unit will cool down for 3
minutes.
28
Advertenties
