Advertenties
has a damp interior but have it repaired. Never immerse
the heater, cord or plug in water and never touch it with
wet hands.
6. The supply voltage and utility frequency, specified on the
machine, need to match those of the socket that is used.
The electrical installation needs to be protected by a
residual current device (max. 30 mAmp).
7. Fully extend the cord before plugging in the heater.
Make sure it does not come into contact with any part of
the heater and prevent it from heating up any other way.
Do not run the cord underneath carpeting; do not cover it
with mats, carpet strips, or similar and make sure it is not
placed in any passageways. Make sure the cord cannot
be stepped on and that no furniture is placed on top of it.
Do not lead the cord around sharp corners and do not
roll it up too tightly after use!
8. If possible, do not use an extension cord, as this poses
the risk of overheating and fire. If the use of an extension
cord is unavoidable, then make sure it is an undamaged,
approved extension cord with a minimum diameter of 2 x
2.5 mm² and a minimum permissible power of 2000
Watt/10Amp. To prevent overheating, always fully
extend the cord!
9. To prevent the circuit being overloaded and fuses being
blown, make sure no other appliances are connected to
the same socket or wired to the same electrical circuit as
the heater.
10. Do not use the heater outdoors and do not use it in
spaces smaller than 15 m³.
11. A heater contains hot and/or glowing and sparking
components. Do not, therefore, use it in areas where
fuels, paint, flammable liquids and/or gasses etc. are
stored.
12. Do not place the heater near, under, or directly opposite
a socket and do not place near an open fire or other heat
source.
13. Do not use the heater near or directly opposite furniture,
animals, curtains, paper, clothes, bedding or other
inflammable objects. Keep them at least 1 metre away
from the heater!
25
Advertenties
