BEFORE FIRST USE
1. Take out the oven from the box and remove all fillers, transport assisting materials and labels.
Check the oven for any damages that might have occurred during transport. If you have any
doubts contact the seller.
2. The oven must be placed on a level, flat, stable and dry surface that is resistant to high temper-
ature. Keep appropriate distance around the oven Do not put and do not start the oven inside
cabinets, shelves or other pieces of furniture.
3. Connect the oven to a grounded supply network and start it for 15 minutes on the highest tem-
perature. This will help heat the oven and rid it of any factory smell. This heating process might
generate slight smoke which will subside in further use.
4. Disconnect the oven, wait until it cools off and clean it and its accessories using guidelines provid-
ed in the "CLEANING AND MAINTENANCE" section.
USING THE OVEN
1. Place the dish on the tray (8) or on the rack (7) and slide them into the oven. When opening and
closing the door (3) use the handle (4). Always put a tray under the wire rack – this will prevent the
fat from leaking onto the bottom of the oven.
NOTE!!! Do not place in the oven any plastic or paper packaging, containers etc.
2. Connect the device to the mains (grounded).
3. Declare the appropriate baking time (2a), temperature (2b) and oven work mode (2c). The control
lamp (2d) will signal the operation of the oven.
4. Preheating of the oven is not needed. This will be useful when baking delicate dishes such as cakes
or rare and medium-rare meats.
5. It is recommended to use the baking tray in the case of smaller food product such as those which
will cause grease and water to fall down during baking.
6. After finishing the baking the countdown timer will give a sound signal – set the work mode
knob (2c) and the thermostat knob (2b) to the (0) position. Disconnect the oven from the power
source.
NOTE!!! To take out the product use kitchen gloves to avoid burns.
7. After the oven cools off clean it immediately according to the guidelines in the chapter "CLEANING
AND MAINTENANCE".
CLEANING AND MAINTENANCE
NOTE!!! Before starting the cleaning and maintenance disconnect the heater from the power
network and wait until it cools off completely. Do not dip it in water or other liquids.
NOTE!!! Do not use abrasive substances or sharp tools to clean the oven, do not use aggressive
detergents and solvents.
1. External and internal surfaces of the oven should be cleaned with a moist wipe and then wiped dry.
2. The tray and rack should be cleaned in warm water with a delicate detergent, rinsed and left to dry.
Do not clean the oven accessories in dishwashers.
3. If you need to exchange the
light bulb follow the instruc-
tions below:
- disconnect the oven from
power network and wait
until it cools off
Type G9 Lamp
Type E14 Lamp
EN
25