Advertenties
6
Adjusting the swivel arm
1. Slacken the locking screw of the swivel arm.
2. Tilt the swivel to the desired position.
3. Tighten the locking screw.
Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶
Use only the Hilti tool tether recommended for your product.
▶
Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining strap #2293133 and the Hilti tool tether #2261970.
▶
Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶
Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a load-bearing structure. Check that both
carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
Operation
Observe the safety instructions and warnings in this documentation and on the product.
Switching on
1. Press the rear section of the on/off switch.
2. Slide the on/off switch forward.
▶
The motor runs.
3. Lock the on/off switch.
Setting the speed
▶
Use the adjusting knob to set the speed.
Belt speed without load
Stage 1
Stage 2
Stage 3
Stage 4
Stage 5
Stage 6
Grinding
CAUTION
Risk of injury! Touching a moving abrasive belt can lead to painful skin abrasion and cut injuries.
▶
Do not touch the moving abrasive belt.
Do not exceed the speed rating printed on the abrasive belt.
Secure the workpiece you are going to file.
1. Lift the band file clear of the work surface.
2. Switch the tool on.
17
▶
The power tool then runs in sustained operating mode.
3. Set the speed.
17
4. Bring the band file with the abrasive belt into contact with the work surface and keep it moving with a steady back-and-forth action.
5. Work with the pulling run of the abrasive belt.
6. Apply moderate pressure and do not press the abrasive belt into the material. Excessive contact pressure can cause the abrasive belt to slip
off the contact roller.
Switching off
▶
Press the rear section of the on/off switch.
▶
The on/off switch jumps into the off position and the motor stops.
*2327539*
2327539
4.3 m/s
5.2 m/s
6.1 m/s
7.0 m/s
8.0 m/s
9.5 m/s
17
Advertenties
