Advertenties
Inserting the battery
WARNING
Risk of injury by short circuit or falling battery!
▶
Before inserting the battery, make sure that the contacts on the battery and the contacts on the product are free of foreign matter.
▶
Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
2
Fitting the side handle
▶
Screw the side handle into the threaded socket.
3
Fitting an abrasive belt
CAUTION
Risk of injury! The abrasive belt can easily tear if the direction of travel is incorrect.
▶
Be sure to install the abrasive belt right way round for the direction of travel. The belt's direction of travel must match the direction-of-travel
arrow on the gear head.
1. Remove the side handle.
2. Swing the housing cover aside.
3. Turn the eccentric screw until it engages. This relieves the tension on the file arm.
4. Center the abrasive belt on the file arm and the drive roller.
5. Release the eccentric screw to tension the file arm.
6. Swing the housing cover back into position in front of the housing.
7. Fit the side handle.
16
Not every abrasive belt matches every file arm. Select the correct combination from the table below and change the file arm if
necessary
16.
Recommended combination for file arm / belt width
9 mm roller, peaked
9 mm roller, crowned
30 mm roller, small
30 mm roller, large
Removing the abrasive belt
1. Remove the side handle.
2. Swing the housing cover aside.
3. Turn the eccentric screw until it engages. This relieves the tension on the file arm.
4. Remove the abrasive belt.
5. Slacken the eccentric screw to relieve the tension on the spring of the file arm.
4
Adjusting the belt run
1. Adjust the belt run by turning the adjusting screw on the file arm.
2. Select the setting that keeps the belt running centered on the contact roller.
3. Set the speed.
17
4. Run the belt at the slowest speed and check your setting.
5
Changing the file arm
1. Remove the abrasive belt.
2. Slacken the adjusting screw.
3. Remove the securing screws and lift off the file arm.
4. Hold the new file arm in position, install the securing screws and tighten them to the specified torque.
Technical data
Tightening torque, securing screws for file arm
5. Fit the abrasive belt.
6. Adjust the belt run.
16
16
3
16
16
4 mm ... 9 mm
4 mm ... 13 mm
13 mm ... 30 mm
13 mm ... 30 mm
2.7 Nm
*2327539*
2327539
Advertenties
