Inhoudsopgave
Advertenties
2
The fridge/freezer must not be laid horizontally
while being transported or moved. If the appliance
has been tilted more than 40°, the power supply
must not be connected until the appliance has
stood upright for at least two hours.
Placement
in cold rooms
Placing the appliance in a room where the
temperature is lower than +16°C (e.g. in unheated
buildings) can pose problems if the appliance has
only one compressor and one control system.
The temperature sensor will register that it is
sufficiently cold and will therefore not start cooling
the refrigerator section. This will also lead to
insufficient cooling of the freezer and possibly
cause the thawing of frozen foods.
Electrical connection
The appliance is intended for connection to
alternating current. The connection values for
voltage (V) and frequency (Hz) are given on the
nameplate 3 in the cabinet.
3
Power must be connected via a wall socket with
switch. The wall socket should be easily
accessible.
All earthing requirements stipulated by the local
electricity authority must be observed. The
appliance plug and wall socket should then give
correct earthing. If in doubt, contact your local supplier
or an authorised electrician.
All manuals and user guides at all-guides.com
WARNING
The flexible cord (mains lead) fitted to this
appliance has three cores for use with a 3-pin 13-
amp or 3-pin 15-amp plug. If a BS 1363 (13-amp)
fused plug is used, it should be fitted with a 13-
amp fuse.
IMPORTANT
The cores in this mains lead are coloured in
accordance with the following code:
GREEN-AND-YELLOW: EARTH
BLUE: NEUTRAL
BROWN: LIVE
These colours might not correspond with the colour
markings identifying the terminals in your plug.
Proceed as follows:
Connect the GREEN-AND-YELLOW core to the
plug terminal marked "E" or by an earth symbol,
or coloured GREEN or GREEN-AND-YELLOW.
Connect the BLUE core to the plug terminal
marked "N" or coloured BLACK. Connect the
BROWN core to the plug terminal marked "L" or
coloured RED.
Illustration
from right-hinged to left-hinged - or vice versa.
Switch the cabinet off by turning the thermostat
knob to "0". Empty the cabinet and lay the
appliance on its back with the doors up. Begin by
removing the door handles. Tilt the cabinet 40° in
order to gain access to the lowest hinge. Remove
25
You can change the
doors from right-hinged
to left-hinged or vice
versa yourself
4
how easy it is to change the doors
GB
Advertenties
Inhoudsopgave
