Advertenties
Basic view
Power options
Dim the screen after
Enable sleep mode
after
Switch off after
Function keys
Basic settings
Remote control
Info
Operating hours
Calibration
operations
Software
Mahr GmbH, MarSurf PS 10
Basic view for the evaluation (horizontal to the left,
horizontal to the right, vertical, results only).
10 s
Idle period after which the screen is dimmed and
30 s
locked.
Never
Tap the screen to light it up again.
Tapping the
30 s
Idle period after which the MarSurf PS 10 goes into
5 min
sleep mode (unless the AC adapter is connected).
Never
When you press the green Start key the instrument
will return to operating mode.
15 min
Idle period after which the MarSurf PS 10 switches
30 min
off (unless the AC adapter is connected).
Never
Assigns a function or parameter to the freely
programmable F1, F2 keys in the basic view.
Select the language for the text displayed.
Language
Date
Enter date (the format depends on the language).
Time
Enter time (the format depends on the language).
mm
Select the unit of measurement "mm" or "inch".
inch
Remote control is enabled, i.e. measurements can
be started on the MarSurf PS 10 via the MarConnect
interface (see Section 5.2).
Save
Saves the information as "machineinfo.pdf".
Compressed file "marlog.tar.gz" is also created, which
should be sent to Mahr Service if a fault occurs.
Battery
Shows the battery capacity in %.
Probe position
Shows the current probe position ("-.- - µm" when
screen is dimmed).
Measurements
Shows the number of measurements performed.
Charge cycles
Shows the number of charging cycles performed.
Standard mode
Shows the normal operating time (in hours).
Economy mode
Shows the operating time in sleep mode (in hours).
Shows the last three calibration procedures
(date, calculated correction value).
Shows the current software version of the MarSurf
PS 10.
symbol unlocks the screen.
15
Advertenties
