Welding In Synergic Mode - Oerlikon CITOSTEP 355C Gebruikershandleiding

pagina van 215

/ 215
Inhoud
Inhoudsopgave
Bladwijzers

Inhoudsopgave

Advertenties

WARNING

Never use defected gun.



Check gas flow with Gas Purge Switch [20] – GMAW

and FCAW-GS process.



Close the right side panel.



The welding machine is now ready to weld.

WARNING

The right side panel has to be completely closed during

welding.

WARNING

Keep the gun cable as straight as possible when welding

or loading electrode through cable.

WARNING

Do not kink or pull cable around sharp corners.



By applying the principle of occupational health and

safety at welding, welding can be begun.

Welding in Manual Mode

When the Control Knob [25] is set in "Manual" position,

welding in Manual Mode is possible.

Manual Mode enables welding:



GMAW



FACW-GS



FCAW-SS

In Manual Mode can be set:



The welding load voltage



WFS



Burnback



Run-in WFS



Preflow Time



2-Step/4-Step

The chart below can be useful for welding setting

selection:

The 2-Step - 4-Step changes the function of the gun's

trigger.



2 Step trigger operation turns welding on and off in

direct response to the trigger. Welding process is

performed when the gun's trigger is pulled.



4-Step mode allows to continue welding, when the

gun's trigger is released. To stop welding, the gun's

trigger is pulled again. 4-step mode facilitates to

making long welds.

The Burnback Time is the amount of time that the weld

output continues after the wire stops feeding. It prevents

the wire from sticking in the puddle and prepares the end

of the wire for the next arc start.

English

Run-in WFS sets the wire feed speed from the time the

trigger is pulled until an arc is established.

Preflow Time adjusts the time that shielding gas flows

after the trigger is pulled and prior to feeding.