Inhoudsopgave
Advertenties
Output Connections
Refer to points [6], [7] and [8] of the images below.
Controls and Operational Features
2
1
3
8
Figure 2
1. Power Switch ON/OFF (I/O): Controls the input power
to the machine. Be sure the power source is
connected to the mains supply before turning power
on ("I"). After input power is connected and the power
switch is turned on, the indicator will light up to
indicate the machine is ready to weld.
2. Thermal Overload Indicator: This lamp
will light up when the machine is
overheated and the output has been
turned off. This can occur if the ambient temperature is
above 40°C or the duty cycle of the machine has been
exceeded. Leave the machine on to allow the internal
components to cool, when the lamp turns off normal
operation is possible.
3. Welding Load Voltage Switch: Adjust the
welding load voltage. CITOSTEP 355 C
have 2 switches (3 and 10 steps).
WARNING
Do not switch Welding Load Voltage [3] during welding.
4. Digital Display Panel: Parameters of welding process
are shown.
Mode Indicators: These lamps show the work
mode of the machine:
the machine works in synergic mode
(automatic mode)
the machine works in manual mode
Display A: It shows the actual welding current
value (in A), and after finishing welding process, it
shows the average value of the welding current.
Depending on Work Mode, after the WFS value is
changed [5], the display A shows;
English
4
5
6
7
Correction of the speed automatically
matched by the machine, in the range
0.75-1.25
The value of adjusted WFS in m/min
Display V: It shows the actual value of welding
load voltage (in V), and after finishing welding
process, it shows the average value of welding
voltage. When the WFS value is changed [5], the
display is blank.
5. WFS (Wire Feed Speed) Control Knob:
Depending on the work mode of the
machine, this knob controls:
Enables
automatically matched by the machine in
the range ±25%.
Enables
feeding speed in the range from 1.0 to
20m/min.
6. EURO Socket: For connecting a welding gun (for
GMAW, FCAW-GS / FCAW-SS process).
7. High Inductance Output Socket: For
connecting a work lead.
8. Low Inductance Output Socket: For
connecting a work lead.
9
9. Hole Plug: For CO
"Accessories" chapter - K14009-1 CO
Connection Kit).
10. Gas Connector: Connection for gas line.
The welding machine supports all suitable shielding
gases at a maximum pressure of 5,0 Bar.
8
correction
of
the
speed
continuous
control
of
10
11
12
Figure 3.
gas heater socket (see
2
2
WARNING
wire
Heater
English
Advertenties
Hoofdstukken
Inhoudsopgave
