Inhoudsopgave
Advertenties
11. Slow-Blow Fuse: It shut off the supply power when the
current exceed 3A. After burn out it need to be
replaced by new one. (See "Spare Parts" chapter).
12. Power lead (5m): Connect the supply plug to the
existing input cable that is rated for the machine as
indicated in this manual, and conforms to all applicable
standards. This connection shall be performed only by
a qualified person.
24
25
23
22
21
20
14
19
13
Figure 4.
13. Work Lead.
14. Wire Drive (for GMAW, FCAW-GS / FCAW-SS
process): 4-Roll wire drive.
15. Welding Wire (for GMAW, FCAW-GS / FCAW-SS).
16. Spooled Wire (for GMAW, FCAW-GS / FCAW-SS):
The machine does not include a spooled wire.
Table 1.
POSITIVE POLARITY
(factory setting)
19
19
English
26
17
18
15
16
17. Wire Spool Support: Maximum 15kg spools. Accepts
plastic, steel and fiber spools onto 51mm spindle. Also
accepts Readi-Reel
spindle adapter.
Be sure that the right side panel of machine is closed
during welding.
18. Shield of Changing Polarity.
19. Terminal Block of Changing Polarity (for GMAW,
FCAW-GS / FCAW-SS process): This terminal block
enables to set the welding polarity (+ ; -), which will be
given at the welding holder.
Positive (+) polarity is set at the factory.
Before welding check the polarity for using wires.
If the welding polarity has to be changed, user should:
Switch off the machine.
Determine the wire polarity for the wire to be used.
Consult the wire data for this information.
Take off the terminal block's shield [18].
The tips of the wire on the terminal block [19] fix as is
shown in the Table 1.
Put on the terminal block's shield.
The right side panel has to be completely closed during
welding.
NEGATIVE POLARITY
19
19
9
®
type spools onto included
WARNING
WARNING
WARNING
WARNING
English
Advertenties
Hoofdstukken
Inhoudsopgave
