Inhoudsopgave
Advertenties
EN
home mode sensors are in disarmed status, users can move freely
within the range of the disarmed area.
Press
[Home Arm
]
on the remote control, the status LED
indicator in the wireless control flashes once to enter home armed
status, and flashes once every 5 seconds later.
Note:
The default zone setting of the PIR motion detector is home mode
zone. When users press
[Home Arm
disarmed status.
Emergency Call
Whenever you press the
[SOS]
will alarm immediately and the alarm LED indicator will flash as well.
After hooting without disarming the system, the status LED indicator
will flash once every 2 seconds.
], the PIR motion detector enters
on the remote control, the system
Enter Connection Status
Through Remote Control
This function is set for users to connect newly-purchased accessories
without dismounting the siren from the wall.
When the siren is in installation mode, press
remote control continuously for 3 times, then the siren comes to
connection status after a long beep is heard. The siren will exit from
connection status when no operation is carried out in 15 seconds.
Zone Setting For Wireless Accessories
The zone setting is set through the inner jumpers of the sensors.
If the zone setting is changed, the accessories need to be
reconnected with the control panel.
The accessory can be set in normal zone, home mode zone or
24-H zone.
Normal Zone:
In arm or home mode status, the system will alarm
immediately once the sensors in normal zone is triggered.
Home Mode Zone:
In home mode status, the system will not alarm
once the sensor in home mode zone is triggered.
EN
[Home Arm
]
on the
Advertenties
Inhoudsopgave
