Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
Connect with PIR Motion Detector
Press Learn button for 0.5 second till a beep is heard, the siren
enters connection status.
Press test button at back of the detector twice continuously, the
connection succeeds when a beep is heard from siren.
Connect with Other Accessories
Connect with other accessories is the same operation; please see
details in the user manuals for accessories.
Note:
Once the siren is in connection status, please press Learn button again
to exit.
(A beep will be heard from siren) When 2 beeps are heard in connection
status, means the sensor has been connected before.
Disconnection
Hold the Learn button in the siren till 2 beeps are heard to
disconnect the accessories from siren.
Installation Mode
Installation Mode is set for users to dismount or remount the siren
without triggering the tamper switch. Thus not to disturb other
people.
Press
[Disarm ]
button on the remote control continuously for 3
times, then the siren comes to installation mode after a long beep is
heard. Any sensor or tamper triggered during installation mode will
not result in siren hooting but 3 beeps will be heard instead.
Press
[Arm ]
button, the siren will exit from installation mode after
a long beep is heard. Or the siren will exit from connection status
when no operation is carried out within 10 minutes.
Note:
Also you can press the tamper switch 7 times to enter installation mode.
EN
Advertenties
Inhoudsopgave
