Inhoudsopgave
Advertenties
EN
Installation
Please finish all the system setup on the PCB and enter into
installation mode before installation.
1. Hold the positioning paper in right place, stick the gradienter on the
positioning paper to check and adjust the position.
2. Install two screws into the top screw holes.
3. Mount the bracket into the bottom screw holes and tighten with
screws.
4. Tear off the positioning paper.
5. Mount the siren to the wall, tighten the screw and make sure the
siren is well positioned.
Gradienter
Positioning
paper
Remote Control Operation
Work as a standalone alarm panel, user can use remote control to
arm, disarm, and mute arm or disarm the siren. SOS emergency call
can be realized.
Arm
Press [Arm
] on the remote control, the status LED indicator in
the wireless control flashes once to enter armed status and flashes
once every 5 seconds later.
Disarm
Press
[Disarm
]
on the remote control, the status LED indicator
in the wireless control flashes twice and then goes out to enter
disarmed status.
Home Arm (Part Arm)
When the system enters home armed status, all the sensors in
normal zone is armed except those in home mode zone. While the
EN
Advertenties
Inhoudsopgave
