Inhoudsopgave
Advertenties
Warning signs
General
Warning:
warning
electricity
en
Obligation signs
Wear eye
Wear a safety
protection
helmet
Symbols
Read the operating
instructions before
use.
A
V
Amps
Volts
~
rpm
Revolutions
Alternating
per minute
current
On the vacuum baseplate
VACUUM
VACUUM
Top:
An additional means of
securing the drill stand must
be employed when used for
horizontal drilling with
vacuum attachment.
Below:
Use of only the vacuum base-
plate to secure the drill stand
for overhead drilling is not
permissible.
18
Printed: 22.11.2013 | Doc-Nr: PUB / 5069597 / 000 / 03
All manuals and user guides at all-guides.com
Warning: hot
surface
Wear ear
Wear safety
Wear safety
protection
gloves
boots
Recycle
waste
material
W
Hz
/min
Watts
Hertz
Revolutions
per minute
∅
n
o
Nominal
Diameter
speed under
no load
On the tool
Use of the water collector
system in conjunction with a
wet-type vacuum cleaner is
mandatory when working
overhead on ceilings.
208188 B/2.2004
Use of a correctly functioning PRCD
circuit breaker is mandatory.
These numbers refer to the corresponding illustra-
tions. The illustrations can be found on the fold-out cov-
er pages. Keep these pages open while studying the
operating instructions.
In these operating instructions, the designation "the
machine" refers to the DD 200 core drilling machine.
Location of identification data on the machine
The type designation and serial number can be found
on the rating plate on the machine. Make a note of this
data in your operating instructions and always refer to
it when making an enquiry to your Hilti representative
or service department.
Type:
Serial no.:
Type:
Serial no.:
DD 200
DD-HD 30
Advertenties
Hoofdstukken
Inhoudsopgave
