Inhoudsopgave
Advertenties
Using an unsuitable charger may present a risk of
shock, overheating or escape of caustic battery fluid.
Refer to the respective "Operating instructions" for further
information on the batteries and the charger.
You only need to charge the battery before starting the device
and insert it into the device.
Charging the battery:
See operating instructions for the battery and/or the
charger.
Inserting the battery:
Slide the battery into the guide of the battery holder until
the contacts of the battery are firmly seated on the contact
plugs of the device (audible click).
Start-up
Caution! Prior to starting the machine learn how to
put it out of action in emergency cases.
You may not start to operate the machine until you
have read these original instructions, observed all
the instructions given and installed the machine as
described!
Check the device before each use for
possible damages,
loose fastening elements
correctly assembled and faultless covers and protective
devices.
Make sure before each startup that the switch
lock (G) and the ON / OFF switch (H) on the operating
handle (F) work properly.
Do not use the device if it can be switched on only
with the ON / OFF switch. The unit must be checked
and repaired immediately by the customer service.
Switching on:
The brushcutter / grass trimmer features a safety circuit
that prevents unintended activation.
Make sure the cutting tool does not lie on the ground
when switching the device on.
Hold the device firmly with both hands; the left hand
always encloses the guide handle (5) and the right hand
the operating handle (F). This applies also to left-handed
persons!
Press the switch lock (G) and then the ON/OFF switch
(H). You can let go of the switch lock (G) during the
cutting process.
To protect the battery the machine automatically
switches off at a low battery.
Never continue operating the ON / OFF switch; this
may damage the battery.
Charge the lithium ion battery (
instructions).
22
("Battery" operating
Speed control of the cutting tool
The speed of the cutting tool can be adjusted infinitely
variable with the ON / OFF switch (H).
When pressing the ON / OFF switch only slightly, the
cutting tool turns at low speed. The further the ON / OFF
switch is pressed, the faster the cutting tool will turn.
Switching off
Release the ON / OFF switch to switch off the device.
The cutting tool continues to rotate for a few seconds
after the unit is switched off.
Economy / Normal mode
The device may be operated in economy mode or in
normal mode.
The device always starts in normal mode.
You can only change the mode when the device is
switched on.
Changing the mode
Press the green button:
The device runs in economy mode.
The battery charge will last longer.
The middle indicator lights up green
when the device is operated in
economy mode.
Press the yellow button:
The device runs in normal mode.
The battery life becomes shorter.
Working with the device
You may not start to operate the machine until you
have read these original instructions, observed all
the instructions given and installed the machine as
described!
Always keep your hands and feet at a safe distance
to the cutting tool.
Transport guard for cutting blade
To avoid injuries to the fingers, the cutting blade (10A) is
equipped with a transport guard (10B).
Remove the transport guard (10B) before switching on the
device.
Carrying strap
Always apply the carrying strap (7) when
working with this machine.
Never wear the carrying strap diagonally over
shoulder and chest, but only on one shoulder. In
this way, you can quicker remove the machine from
your body if you get in a dangerous situation.
Advertenties
Hoofdstukken
Inhoudsopgave
