Handwash in cold water
30° C
Do not bleach
° C
Do not tumble dry
Do not iron
Do not dry clean
• Check that the fabric and stitching are in good
condition each time you wash it.
• Prolonged exposure to direct sunlight can
cause the fabric to fade.
REMOVING THE FABRIC FROM THE CHILD
CAR SEAT
The lining of the child car seat is washable. To
perform this operation, you need to remove it
the structure of the child car seat.
1. Move the handle to a vertical position and
remove the hood by releasing it from the rel-
evant hooks and buttons (Fig. 26).
2. Release the plastic flaps located near the
handle joints with the belts unfastened (Fig.
27).
3. Pull off the lining from the front of the seat,
taking care to remove the lining at the belt
adjustment button (Fig. 28); release the fabric
from the belt guides (Fig. 29).
4. Lift the fabric from the back of the child car
seat, pull off the shoulder straps and crotch
strap from the fabric.
5. To fit the lining on the child car seat again,
repeat the steps described above in reverse
order.
FASTENING THE CHILD CAR SEAT ON THE
STROLLER
6. To fasten the Child Car Seat, remove the
stroller or carrycot seat, if present.
7. Hold the handle in the transport position
(Fig. 30) and position the Child Car Seat on
the lateral hooks of the stroller with the foot
zone facing rearward. Ease it on the frame
until you hear a click (Fig. 31).
WARNING: Before use, ensure that the Child
Car Seat is properly fastened by pulling up on
it. If it does not attach, press the H release but-
ton (Fig. 32) and repeat the process.
8. To release the Child Car Seat from the stroller,
put the handle in the vertical position (trans-
port), push the button located on the back
of the backrest and lift it up from the frame
(Fig. 32).
WARNING: The fastening and releasing op-
erations can be carried out also with your child
inside the car seat; however, the child's weight
may make these operations more difficult.
Pay attention when carrying out the above
mentioned operations.
WARRANTY
The product is guaranteed against any con-
formity defect in normal conditions of use as
provided for by the instructions. The warranty
shall not therefore apply in the case of damage
caused by improper use, wear or accidental
events. For the duration of the warranty on
conformity defects please refer to the specific
provisions of applicable national laws in the
country of purchase, where appropriate.
22