Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Reading each Memory Program's Cycle Counter
1. Clear all operations by pressing the Stop/cancel
(
) button.
Press the Check button to enter Check mode.
2. Press the Start (
) button, and then press any
Number button, from 1 to 20, and the number of
cycles for that particular Memory Program will be
displayed. The cycle count is displayed in units of
10.
For example, if Memory Program 5 has been used
100 times, the display will show '10'.
As the display uses units of 10, the cycle counts are approximate. The
cycle count displayed increases every ten cycles.
For example, if the cycle count were 90-99, "9" would be displayed,
The "9" would change to "10" on the 100th cycle. The cycle counter
function has a limit of 99,990 cycles. Once that number is exceeded,
the cycle counter will automatically clear and start again from "0".
3. After one second, the display will clear
automatically. If you want to check other Memory
Programs, just enter the Memory Program
numbers.
4. Press the Stop/cancel (
Checking mode.
CM1089A_XEU_DE68-03310E_EN.indd 17
) button to exit the
rESETTING THE mEmory proGram cycLE coUNTEr
1. Clear all operations by pressing the Stop/cancel
(
) button.
The display will show ':0".
2. Hold the Number '0' and then press defrost (
button.
The microwave will emit a Beep sound confirming
the reset operation.
Clearing all numbers on the display using the Stop/
Cancel button will show "0" as below.
3. Press the Stop/cancel (
) button to exit the
Resetting mode.
SETTING THE SoUNd
1. Press the Sound button to adjust sound volume.
The basic sound volume is "LO" and when you
press the Sound button repeatedly, the sound
volume changes in the following order - MED, HI,
OFF, LO one by one.
2. Press the Start (
) button to exit Sound mode.
The display will show ":0".
Indicator
HI
MED
LO
Blank
17
)
Sound
Loud
Middle
Low
Off
3/20/2013 3:17:24 PM
Advertenties
Hoofdstukken
Inhoudsopgave
