Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Cleaning tips/mode of operation
–
Always work from the light to the shade (from the
window to the door).
–
Always work from the cleaned to the uncleaned
surface.
–
Rugs with jute backing can shrink if too much water
is used and can bleed colours.
–
Brush high-fiber rugs in the direction of the weave
after cleaning (using a fiber brush or a scrubber).
–
Water-proofing the fabric using Care Tex RM 762
after the wet cleaning prevents a quick resoiling of
the textile surface.
–
Do not step on cleaned surfaces until they have
dried and do not place furniture on them to avoid
pressure spots or rust stains.
Cleaning methods
Light/normal contamination
Turn on suction and spraying (position I).
Spray and simultaneously suction off detergent so-
lution in one work cycle.
Switch off the spray switch and suction off the re-
maining cleaning solution.
After cleaning the carpets, reclean them using
clear, warm water and waterproof if needed.
Heavy soiling or stains
Switch on sprayer (position I).
Apply detergent solution and allow to react for 5
minutes (vacuuming is switched off).
Clean the surface just like you would with light/nor-
mal soiling.
After cleaning the carpets, reclean them using
clear, warm water and waterproof if needed.
End wet cleaning process
Rinse the spray tubes in the appliance as follows:
Fill the detergent container with about 1 liter of
clear water.
Hold the nozzle above the drain, and switch on the
spraying pump until the clear water has been con-
sumed.
Dry vacuum cleaning
ATTENTION
Always ensure that the filter bag is inserted for dry vac-
uuming.
Better filtration can be achieved by using a cartridge fil-
ter (special accessories).
Container and accessories must be dry, otherwise dirt
may adhere.
Illustration
Insert a filter bag.
Illustration
Use the adapter for wet/dry vacuuming Attach the
adapter to the handle, turn the locking handle to se-
cure it.
Select the desired accessories and attach to the
spray/suction pipes or directly to the attachment.
Switch on suction (position I).
Vacuuming hard surfaces
Illustration
Insert the hard surface inlay into the floor nozzle.
The bristles should point towards the front.
Vacuuming carpeted floors
Illustration
Work without the hard surface insert.
Use the surrounding air separator to adapt the suc-
tion force.
Note:
Close the surrounding air separator again after use!
Wet vacuum cleaning
Caution:
Do not use a filter bag!
Immediately switch the appliance off if foam forms or liq-
uids escape!
Note: If the container is full, a float closes the suction
opening, and the appliance works at a higher speed.
Switch off the appliance immediately, and empty the
container.
Use washing nozzle to vacuum up wet dirt/water.
If you use a crevice nozzle:
Attach and secure the adapter for wet/dry vacuum-
ing. Install the crevice nozzle directly to the adapt-
er.
Switch on suction (position I).
Illustration
Open the surrounding air separator if water is suc-
tioned from a tank. Close it again after use.
Empty the full reservoir (refer to chapter "Empty
reservoir").
Turn off the appliance.
Empty the full reservoir (refer to chapter "Empty
reservoir").
Rinse the reservoir thoroughly with clear water.
Separate the handle, the spray/suction hoses and
the wash nozzle from each other; open locking le-
ver to achieve this (centre position),
Flush the accessories separately under running
water and let air dry.
Clean the foam filter under running water; let it dry
before reinserting it.
Leave the appliance open to let it dry.
Storing the appliance. Store the accessories on
the appliance and store in dry rooms.
Maintenance and Care
DANGER
Turn off the appliance and remove the mains plug prior
to any care and maintenance work.
Repair works may only be performed by the authorised
customer service.
WARNING
Do not use abrasives, glass or universal cleaners! Nev-
er immerse the appliance in water.
Clean the spray nozzle
With an uneven spray jet.
Illustration
Loosen nozzle attachment and pull out, clean or re-
place spray nozzle.
Clean the sieve in the fresh water reservoir
1 x year or as needed.
Illustration
Turn the lock and loosen it. Take out the sieve and
rinse it with water.
EN
– 9
Shutting down
15
Advertenties
Inhoudsopgave
