Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Fitting the camera
Only for CAM35 NAV
The cameras CAM35REAR NAV and CAM35 TWIN NAV can be connected to
monitors from other manufacturers. A universal adapter is included (CAM35 NAV
adapter).
6
Fitting the camera
6.1
Dismantling the brake light
➤ Remove the two screws of the brake light (fig. 9, page 5).
➤ Remove the plug of the brake light (fig. 0, page 6).
6.2
Laying cables
A
NOTICE! Beware of damage.
• When drilling holes, check beforehand that there is sufficient space
on the other side for the drill head to come out.
• Cables and connections that are not properly installed will cause
malfunctions or damage to components. Correct installation of
cables and connections ensures lasting and trouble-free operation of
the retrofitted components.
• The cables may not be exposed for long periods to solvents such as
benzene, since solvents can damage the cable.
Therefore, please observe the following instructions:
• As far as possible, use original ducts for laying the cables, or other suitable
options such as panelling edges, ventilation grilles or dummy plugs. If no open-
ings are available, you must drill holes for the cables. Check beforehand that
there is sufficient space on the other side for the drill head to emerge.
• Wherever possible, lay cables inside the vehicle, as they are better protected
there than outside.
If you do need to lay a cable outside the vehicle, ensure that it is well fastened (use
additional cable ties, insulating tape etc.).
14
CAM35
EN
Advertenties
Hoofdstukken
Inhoudsopgave
