Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
after terminating cooking.
The control switches are located on the
hood's front panel:
A
B
A
OFF – ON push button
Press once or more to obtain the
function desired:
ON: the hood switches on to the last
speed selected.
OFF: all the functions are switched off
except the illumination.
B
Speed selection push button (extraction
power).
Press this push button once or more
to select the most suitable extraction
speed (power) (1-2-3).
C
The display shows the extraction power
selected, signalling the saturation of the
fi lters F.
D
Intensive speed on/off. The Intensive
speed runs for 5 minutes:
If the hood is on when the Intensive
speed is activated, the hood reverts to
previous speed after 5 minutes.
If the hood is off when the Intensive
speed is activated, the hood will be
turned off after 5 minutes.
To interrupt the Intensive speed, press
button
A
or
B
.
E
Light ON/OFF
Should the hood or the controls fail to
operate: disconnect the power supply for at
least 5 seconds, then turn the hood back
on again.
Grease and charcoal fi lter maintenance
indicator
This hood is fi tted with a device that
indicates when it is necessary to clean the
grease fi lter or the charcoal fi lter (if the
hood is used in the recirculation version
with a charcoal fi lter).
On delivery, the hood is not supplied with
a charcoal fi lter, so the saturation indicator
will be disabled.
If the hood is to be used with a charcoal
fi lter, the saturation
indicator light must be enabled as follows:
C
D
E
Set the hood in "OFF".
Pressing keys
B
and
for three seconds, LED F lights up and
begins to fl ash the 1st speed led. After 1
second the 2nd speed led also fl ashes and
the system emits a sound signal (-Beep-) to
indicate setting taking place.
To remove the charcoal fi lter signal press
push buttons
B
and
3 seconds. LED F lights up and begins to
fl ash the 1st speed led (grease fi lter) and
the 2nd speed led. After 1 second, only
the 1st speed led continues to fl ash. The
system emits a sound signal (-Beep-) to
indicate setting taking place.
Grease fi lter LED
The 1st speed led (+ led F) fl ashes, when it
is time to clean the grease fi lter.
Always comply with the maintenance
instructions for the grease fi lter.
Charcoal fi lter LED
The 2nd speed led (+ led F) fl ashes,
when the charcoal fi lter needs to be
cleaned or replaced.
Resetting the saturation indicator
After cleaning or replacing the fi lters, press
button
A
for 3 seconds until the 1st speed
led or the second speed led stops fl ashing.
The F LED also turns off.
6. LIGHTING
Disconnect the hood from the electricity.
Warning! Prior to touching the light bulbs
ensure they are cooled down.Replace with
a new 12 Volt, 20 Watt (Maximum) halogen
light made for a G-4 base SUITABLE FOR
USE IN OPEN LUMINAIRES. Follow
package directions and do not touch new
light with bare hands.
ENGLISH
D
simultaneously
D
simultaneously for
5
Advertenties
Inhoudsopgave
