Acer Aspire Series Gebruikershandleiding pagina 82
Verberg thumbnails
Zie ook voor Aspire Series:
- Gebruikershandleiding (121 pagina's) ,
- Snelgids (12 pagina's) ,
- Gebruikershandleiding (64 pagina's)
Advertenties
Beschikbare talen
Beschikbare talen
61
countries, the approval does not, of itself, give an unconditional assurance of
successful operation on every PSTN termination point. In the event of problems, you
should contact your equipment supplier in the first instance. For more information
about applicable countries, please refer to "Regulations and safety notices" on
page 59.
Notice for Australia
For safety reasons, only connect headsets with a telecommunications compliance
label. This includes customer equipment previously labeled permitted or certified.
Notice for New Zealand
1
The grant of a Telepermit for any item of terminal equipment indicates only that
Telecom has accepted that the item complies with minimum conditions for
connection to its network. It indicates no endorsement of the product by
Telecom, nor does it provide any sort of warranty. Above all, it provides no
assurance that any item will work correctly in all respects with another item of
Telepermitted equipment of a different make or model, nor does it imply that
any product is compatible with all of Telecom's network services.
2
This equipment is not capable, under all operating conditions, of correct
operation at the higher speeds for which it is designed. Telecom will accept no
responsibility should difficulties arise in such circumstances.
3
Some parameters required for compliance with Telecom's Telepermit
requirements are dependent on the equipment (PC) associated with this
device. The associated equipment shall be set to operate within the following
limits for compliance with Telecom's Specifications:
a
There shall be no more than 10 call attempts to the same number within
any 30-minute period for any single manual call initiation, and
b
The equipment shall go on-hook for a period of not less than 30 seconds
between the end of one attempt and the beginning of the next call attempt.
4
Some parameters required for compliance with Telecom's Telepermit
requirements are dependent on the equipment (PC) associated with this
device. In order to operate within the limits for compliance with Telecom's
specifications, the associated equipment shall be set to ensure that automatic
calls to different numbers are spaced such that there is not less than 5 seconds
between the end of one call attempt and the beginning of another.
5
This equipment shall not be set up to make automatic calls to Telecom's 111
Emergency Service.
6
This device is equipped with pulse dialing while the Telecom standard is DTMF
tone dialing. There is no guarantee that Telecom lines will always continue to
support pulse dialing.
7
Use of pulse dialing, when this equipment is connected to the same line as
other equipment, may give rise to bell tinkle or noise and may also cause a
Advertenties
