Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
-
If the visor and/or VPS opening/closing mechanisms are damaged or malfunctioning,
please contact an X-lite authorized dealer.
-
Do not use the helmet if the VPS has not been assembled properly.
WARNING!!!
The VPS does not replace the protection guaranteed by the visor.
•
WIND PROTECTOR
This accessory allows improved helmet performance under certain conditions of use.
The Wind Protector reduces unpleasant infiltrations of air under the chin.
See Fig. 17 for the assembly and disassembly.
WARNING!!!
The Wind Protector can be easily removed. You can check the correct assembly of this
accessory by pulling it gently towards the inner part of the helmet with your thumb and
forefinger. If it moves, repeat the assembling operations.
•
ROLL NECK
1
DISASSEMBLY
1.1 Undo the chin strap.
1.2 Pull out the chin strap ends from the loops in the roll neck (Fig. 18).
1.3 Release the button on the back of the left cheek pad (Fig.21), release the roll neck eye-
let fastener (Fig. 19) and hook the cheek pad again. Repeat the same operation for the
right cheek pad.
1.4 Open the zip and remove the roll neck (Fig. 20).
1.5 After removing the roll neck, it is necessary to check that the chin strap is adjusted cor-
rectly (see attached label).
2
ASSEMBLY
2.1 Undo the chin strap.
2.2 Insert the roll neck, fasten it and close the zip.
2.3 Insert both ends of the chin strap in the specific loops on the roll neck (Fig. 18).
2.4 Release the button on the back of the left cheek pad (Fig. 21), hook the roll neck eyelet
fastener (Fig. 19) and hook the cheek pad again. Repeat the same operation for the right
cheek pad.
2.5 Before using the helmet, make sure that the sliding clip of the zip does not protrude from
the helmet itself and that it is correctly bent and folded between the roll neck padding
and the chin strap.
2.6 After assembling the roll neck, it is necessary to check that it is adjusted correctly.
•
TOURING PERFORMANCE COMFORT - INNER COMFORT PADDING
To remove and/or reassemble the inner comfort padding, open the helmet chin guard and lift
the VPS (Fig. 15).
1
DISASSEMBLY OF THE CHEEK PADS
1.1 Open the chin strap (see specific instructions) and pull the front part of the left cheek
pad towards the inside of the helmet to release the snap fasteners on the rear of the pad
(Fig. 21).
1.2 Remove the padding of the left cheek pad from the helmet by pulling the left chin strap
out of the cheek pad slot.
1.3 Repeat these steps with the padding of the right cheek pad.
19
Advertenties
Inhoudsopgave
