Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
WARNING!!!
-
Use the special slider to activate/deactivate the VPS; do not deactivate the VPS by han-
dling it directly.
-
The VPS can be activated only during the day and under the environmental conditions
described before.
-
At night and/or in poor visibility conditions, the VPS MUST be deactivated.
-
Always check that the VPS is properly positioned according to the different
weather/environmental conditions and/or to the above mentioned recommendations for
use.
-
We recommend using the VPS only and solely together with the approved standard
visor, which has a transmittance value greater than 80%.
-
Since the VPS does not assure you the same protection as the one provided by the
visor, it has to be used only when the helmet visor is pulled down.
-
Always make sure that the VPS is clean and that it is operating properly in order to avoid
scratches and/or anomalous wear on it every time it is activated.
-
ALWAYS check the correct VPS operation. In case of malfunctioning do not use the hel-
met and contact a X-lite authorized dealer immediately.
-
Please refer to the proper section in the helmet user's manual for the VPS and visor
maintenance and cleaning operations.
-
The VPS scratch-resistant and fog-resistant treatment highly reduces fogging.
Protracted periods of adverse weather and/or environmental conditions might cause
fogging and/or formation of condensation on the VPS, which entails a reduction of visi-
bility and/or sharpness of vision: in this case, deactivate the VPS.
-
In case of rain, the direct contact of raindrops with the scratch-resistant and fog-resi-
stant treated VPS quickly reduces sharpness of vision, thus causing scarce visibility: in
this case, deactivate the VPS.
-
The special VPS fog-resistant treatment is usually sensitive to high temperatures or heat
sources. In this case, contaminations caused by contact with other materials might
occur. These contaminations will cause marks and stains to develop. In these cases
(e.g. when the helmet is kept in the top case on hot days), it is recommended to make
sure the visor is not touching other materials.
1
VPS DISASSEMBLY INSTRUCTIONS
1.1 To disassemble the VPS, open the helmet visor and make sure the side slider is in dow-
nward position (Fig. 14).
1.2 Hold the left part of the VPS and pull it outwards until the grip pawl is removed from the
VPS mechanism (Fig. 16).
1.3 Repeat the same steps on the right side of the VPS and remove it.
2
VPS ASSEMBLY INSTRUCTIONS
2.1 To assemble the VPS, open the helmet visor and make sure the side slider is in upward
position (Fig. 14).
2.2 Insert the left end of the VPS into the left side guide until the grip pawl is hooked in the
mechanism (Fig. 16).
2.3 Repeat the same steps on the right side.
2.4 Check the correct VPS operation by moving the left side slider downwards (Fig. 15) and
upwards (Fig. 14) until you hear the clicks meaning that it is in the relevant positions.
If necessary, repeat the above-mentioned steps.
18
Advertenties
Inhoudsopgave
