Inhoudsopgave
Advertenties
Problem
Cause
1. Blade tension is too high
Shaving head
gets very hot
2. Blades or head run dry
1. Eccentric defective
Blades do not
2. Primary reduction
cut
3. Shaving head worn out
1. Blade tension is too low
2. Blades have rust
3. Shearing blades are blunt
Blades cut badly
11
TRANSPORT AND STORAGE
WA R NI N G
»
Before storing the charging station, make sure that it is disconnected from
the power supply.
»
Store the device, battery and charging station in an environment that is not
accessible to children and third parties to prevent misuse of the device.
»
Store the battery only at an ambient temperature between 0°C and +40°C and
ensure that the environment is free of moisture.
N OTICE
»
Do not store the device, battery or charging station in direct sunlight.
»
Store the device and charging station only at an ambient temperature between
0°C and +40°C and make sure that the environment is free of moisture.
»
For longer storage of the device, remove the battery from the device.
»
When transporting the device, pack it in such a way that it is protected from
shocks. Ideally, use the original packaging.
»
Do not wrap the cable around the charging station. Breaks in the insulation and
cable damage can result.
26
Shaving head/blade
gearing defective
or not sharpened properly
INSTRUCTION MANUAL VOSS.FARMING PROFICUT GO
Solution
1. Adjust the tension of the blades with the
tensioning nut. If this solves the problem
and the device does not cut, the blades
must be sharpened.
2. Oil the blades/head.
Contact the service department.
1. Increase the tension of the clipper blades
with the tensioning nut.
2. Have the clipper blades resharpened at a
specialist shop. If there is too much rust,
replace the blades with new ones.
3. Have the clipper blades resharpened by
a specialist.
85345 - 02.2024 - V4
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
