Inhoudsopgave
Advertenties
7.5
CHANGING BLADES
A set of blades consists of an upper and a larger, lower blade whose ground sides always lie on
top of each other.
CAUTION
Keep your fingers away from the sharp edges of the blades to avoid injury.
1. Switch off the clipper and remove the battery from the device (see section 7.4).
WA RNIN G
Only carry out the following steps after ensuring that the device has been switched
off and the battery removed.
2. To loosen the tension on the
blades, turn the tensioning
nut (2).
The blades are now loose.
3. Turn the clipper over and
place the clipper on a flat,
stable surface.
The fixing screws (7) are at the
top.
4. Loosen the fixing screws (7)
using the enclosed wrench
(Fig. 5).
NOTICE
Do not remove the fixing screws (7) completely.
You can remove the old blades.
5. Make sure that the new blades, especially the grinding sides,
are free of impurities.
6. Insert the upper blade into the guide points of the oscillating
head.
7. Oil the upper blade on the grinding surfaces with the oil (Fig. 6).
8. Slide the lower blade between the loosened fixing screws (7).
9. Position the lower blade so that it protrudes approx. 1.5 to 2
mm beyond the upper blade (Fig. 7).
10. Tighten the fixing screws (7) using the enclosed wrench.
8
CLEANING
WA R NIN G AGA IN ST ELE CTRICAL VOLTAGES
Keep the device away from water or other liquids, electric shock or short circuit
may result.
CAU TI ON
Be careful to keep fingers away from the sharp edges of the blades to avoid injury.
N OTICE
Do not use aggressive solvents/cleaning agents, brushes, sharp objects etc. for
cleaning. These can damage the surface.
22
INSTRUCTION MANUAL VOSS.FARMING PROFICUT GO
Fig. 5
~ 1,5 – 2 mm
Fig. 6
Fig. 7
85345 - 02.2024 - V4
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
