Inhoudsopgave
Advertenties
INSTRUCTION MANUAL VOSS.FARMING PROFICUT GO
10
TROUBLESHOOTING
N OTI CE
»
Do not make any improper changes or modifications to the device.
»
Never open the housing. Contact the service department for repairs.
If the device malfunctions or is found to be otherwise defective, even after following the suggested
solutions below, contact the service department. The contact details can be found in chapter 14.
Problem
Cause
1. Battery empty
Motor does not
2. Battery, switch or motor
work
1. Rotor runs out of round
2. Bearings are worn out
Motor vibrates
3. Fan wheel broken
1. Air filter is blocked
2. Blade tension is too high
3. Blades or clipper head
Motor gets hot
4. Defective ball bearing
Motor is very
Bearing seized
loud
1. Battery almost empty
Motor runs very
2. Carbon brushes worn out
slowly
3. Rotor or stator defective
Problem
Cause
Upper blade
Defective reduction drive
does not move
Upper blade
1. Eccentric worn out
does not move
over the entire
2. Eccentric shaft defective
running surface
85345 - 02.2024 - V4
Motor
defective
run dry
Shaving head/blade
Solution
1. Change and charge the battery as described
in sections 7.4 and 9.1.
2. Contact the service department.
Contact the service department.
1. Clean or replace air filter.
2. Reduce the tension of the blades with
the tensioning nut. If this solves the
problem and the device does not cut, the
blades must be sharpened.
3. Oil the blades/head.
4. Contact the service department.
Contact the service department.
1. Change and charge the battery as described
in sections 7.4 and 9.1.
2. Contact the service department.
3. Contact the service department.
Solution
Contact the service department.
Contact the service department.
DE
EN
FR
IT
NL
SV
ES
PL
25
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
