Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
2.1.3. Drive/tube assembly
1) Slide the drive into the roller tube.
For roller tubes which are smooth inside, position the notch
previously cut on the boss on the crown.
2) Fix the tube to the motor with self-tapping screws or steel
pop rivets depending on the dimension (L1).
The screws or pop rivets must only be attached to the
drive wheel and not to the drive.
2.1.4. Installing the drive/tube assembly
1)
(f) and onto the drive bracket (g) :
assembly from coming out of the end bracket mounting.
2)
place.
2.2. WIRING
Cables which pass through a metal wall must be protected and isolated using a sheath
or sleeve.
Attach cables to prevent any contact with moving parts.
If the drive is used outdoors and if the power supply cable is of the H05VVF type, then run the
cable in a UV-resistant conduit, e.g. trunking.
The cable for the Oximo 40 io cannot be removed. If it is damaged, return the drive to the After-
Sales department.
Always make a loop in the power supply cable to prevent water entering the drive!
Leave the drive power supply cable accessible: it must be possible to replace it easily.
Switch off the power supply.
-
Connect the drive according to the information in the table below:
-
230 V
50 Hz
Copyright © 2016 Somfy SAS. All rights reserved.
Neutral
Live
(N)
(L)
Blue
Brown
1)
2)
h) in
Earth( )
-
Images not contractually binding
L1
1)
g
2)
h
OFF
N
L
230 V
50 Hz
EN
f
3
Advertenties
Hoofdstukken
Inhoudsopgave
