Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Make sure it is firmly positioned. Do not use
any force when assembling or setting up the
product, e.g. hammer blows. This will damage
the product. In order to achieve the best result,
set the solar fairy lights garden set up in a place
where the solar cell will get direct sunlight for
as long as possible.
Make sure the solar cell is not impacted by other
light sources, e.g. yard- or street lighting, or the
light will not switch on at twilight. In low light the
light will automatically switch on, and automati-
cally switch off in normal ambient light.
Insert the lanterns
6
so far into the ground (lawn, flower bed) that
they are positioned securely and upright in the
ground (see Fig. C).
Switching the fairy lights
on / off (see Fig. D)
Slide the switch
10
switch the fairy lights
will automatically switch on or off at twilight.
Slide the switch
10
switch the fairy lights
RGB mode
Slide the switch
10
RGB mode.
When colour changing is activated, you can
press the MODE button
rent colour or you can continue with the colour
changing by pressing the MODE button
again. In position "W", the LEDs light up white.
Replacing the
rechargeable battery
Note: For optimal performance, the rechargeable
battery should be replaced every 12 months.
Slide the switch
10
switch the fairy lights off.
with the ground stakes
to position "W" or "C" to
on. The fairy lights
8
to the "OFF" position to
off.
8
to position "C" to activate
to freeze the cur-
9
9
to the "OFF" position to
Use a small cross-tip screwdriver to remove the
fixing screws
to pry open the solar panel
cell housing
Replace the old battery with a new one; be sure
not to damage the cables. Be sure to insert the
batteries in the correct direction. This is indicated
in the battery compartment. Use only recharge-
able batteries of the recommended type (see
"Technical data").
Place the solar panel
housing
again and tighten the fixing screws
2
using a small cross-tip screwdriver (see Fig.
7
12
A and D).
Slide the switch
switch on the fairy lights
RGB light respectively.
Charging
The battery charging period using the solar cell de-
pends on the intensity of the sunlight and the angle
8
incidence of the light on the solar cell. Place the so-
lar cell as perpendicular as possible to the angle of
light incidence. In this way you will receive the high-
est light levels. The rechargeable battery only charges
when the product is switched on. For this purpose,
slide the switch
10
Maintenance and cleaning
The LEDs cannot be replaced. The solar fairy lights
garden set is maintenance-free, except for any nec-
essary change of rechargeable battery.
Routinely clean the solar fairy lights garden
set with a dry, lint-free cloth. Use a slightly
moist cloth if very dirty.
Troubleshooting
Note: The device contains sensitive electronic
components. Radio transmitting equipment in the
immediate vicinity may therefore cause interference.
If you notice the device is malfunctioning, remove
. Then use a slotted screwdriver
12
on the solar
1
(see Fig. D).
2
onto the solar cell
1
to position "W" or "C" to
10
with white light or
8
to position "W" or "C".
GB/IE/NI
9
Advertenties
Hoofdstukken
Inhoudsopgave
