Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Dust Exhaustion
Dust which occurs during your work is hazardous to health. That is why it is
advisable to use a deduster and to wear a dust mask on dry drilling. Place
the adapter for the dedusting unit onto the bit holder. As a suitable wet/dry
deduster, our DSS 25 M is available as add-on. The use of a dedusting
system is also a prerequisite for optimal cutting performance of the bit (air
cooling).
Changing Gears
1st gear
520 min
-1
2nd gear
1250 min
-1
3rd gear
2700 min
-1
Warning!
!
• Only change gears whilst the tool is not in operation!
• Never apply force
• Never use tools, such as hammers or pliers to change the
gear.
Manual Drilling
Manual Drilling
Rig drilling
Manual Drilling
Open the ball valve and switch the tool on.
Hold the tool tight with both hands. Locate the tool slightly inclined. Once
the drill bit is in the material (approx. 1/8 to 1/4 of the circumference), bring
the tool into an angle of 90 degrees and continue drilling.
The PLD 182 NT is equipped with a 3-gear oil-
bath gearing. Select the speed according to the
drilling diameter.
Use the gear selector to change to next higher or
lower gear.
If gear changing is too heavy, slightly turn the
working spindle to ease gear changing.
Diameter mm
42 – 72
12 – 42
72 – 182
42 – 72
12 – 42
22
Gear
2
3
1
2
3
Advertenties
Inhoudsopgave
