Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Nosepiece wear criteria
Status
New condition
Worn
Have it replaced by
Hilti Service
8.3.4
Cleaning and oiling fastening tool
Use only Hilti spray. The use of other lubricants can cause malfunctions or damage the fastening tool.
Apply the Hilti spray only as a thin film. It is not permissible for beads to form. For example, after
applying the Hilti spray, rub the oiled surface down lightly with the cloth supplied with the spray.
Make sure that no oil makes its way into the cartridge chamber!
1. Unload the fastening tool (cartridges and fasteners) and dismantle the fastening tool. → page 10
2. Use the brushes supplied to clean the piston and piston guide (outside (1) and inside (2)).
3. Use the small round brush to clean the cartridge chamber (3) and the adjacent holes for the power
regulation pin (3).
4. Clean the seat of the piston guide in the fastening tool (4).
5. Oil the piston guide (outside) and wipe off the piston lightly with a cloth (5).
▶ Make sure that no oil makes its way into the cartridge chamber!
6. Oil the slide rails of cycling grip (6).
8.3.5
Final check of the fastening tool
▶ After carrying out care and maintenance, check that all protective and safety devices are fitted and that
they function faultlessly.
9
Troubleshooting
WARNING!
Before you start troubleshooting, make sure there are no cartridges in the fastening tool. If the cartridges
cannot be removed, contact Hilti Service
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem by
yourself, please contact Hilti Service.
Malfunction
Cartridge is not transported
12
English
Illustration showing example
10
Possible cause
Cartridge strip damaged
Fastening tool is damaged
Annotation
Obvious signs of chipping.
Action to be taken
▶ Remove the cartridge strip and
insert a new strip.
▶ Contact Hilti Service.
282472
*282472*
Advertenties
Inhoudsopgave
