Download Inhoudsopgave Inhoud Print deze pagina

Preliminary Measures Prior To Starting Up; Device Installation; Turning On/Off The Fan And Heating Levels; Temperature Setting - SilverCrest 459221 2401 Bedienings- En Veiligheidsinstructies

Straalkachel
Inhoudsopgave

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

  • DUTCH, pagina 39
3. Preliminary Measures prior to
Starting Up

3.1 Device Installation

Remove all packaging material and all trans-
port bracing from the device.
For a safe and trouble-free running of the device,
choose the installation location which meets the
following requirements:
The floor should be firm, flat and horizontal.
Keep the following minimum clearances from
the device housing: 50 cm from its lateral side,
50 cm above, 50 cm from its rear side and
1 m from its front side.
Do not place the device in a hot and wet or
very humid environment or near combustible
material.
The socket should be easily accessible so that
the mains connection cable can be easily
disconnected, if necessary.
Temperature range: from 0 to +40 °C
Air humidity (no condensation): 5–75 %
Please note: When you use the device the first
time, a slight odour may occur.
4. Starting Up
4.1 Turning ON/OFF the Fan and
Heating Levels
Make sure that the heating level switch 2 is set
on "0". Connect the device to a power outlet.
Then turn the appliance ON by clockwise
turning the temperature regulator 4 until you
hear a click and set the heating level switch
2 to the desired position. The control light 3
illuminates. Thus defined:
0
Position OFF
Fan position
Heating
level 1
Heating
level 2
MIN position of the thermoregulator
MAX position of the thermoregulator

4.2 Temperature Setting

Start the device with setting the desired heating
capacity with the aid of the heating level
switch 2   .
Turn the temperature regulator 4 in a clock-
wise direction as far as it will go.
If the heating level
switch 2 is in this
position, the device is
turned off.
When the heating
level switch 2 is in this
position, only the fan is
running. If you would
like to use the device as
a fan, move the switch
to this position.
If the heating level
switch 2 is in this
position, the fan heater
develops a heating
power of 1000 W.
If the heating level
switch 2 is in this
position, the fan heater
develops a heating
power of 2000 W.
GB/IE/NI/CY/MT
11

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

Shl 2000 b1

Inhoudsopgave